Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
An appropriate way to say no c/o?
#1
Sometimes when I begin selling a high-valued item, I'll get a flood of people asking me what the h/o or c/o is, but I haven't gotten one yet. I tell them, "No c/o yet." and they go "ewwwww".

How do I avoid this?
Reply
#2
Say "Wanna make one?" instead of "No c/o yet"
Reply
#3
Do as GMS says, or say that the c/o is currently something you'd expect it to be worth, maybe 5 mill less.

Or be mean and do as I have done, set c/o at a really high pricetag. Managed to milk out 350 mill for meteor 30 and 1.2 billion for MW 20 through that way at the start of HT-killings.
Reply
#4
Devil's Sunrise Wrote:Or be mean and do as I have done, set c/o at a really high pricetag. Managed to milk out 350 mill for meteor 30 and 1.2 billion for MW 20 through that way at the start of HT-killings.

I always do this.
I usually walk away with more than I expected.
Reply
#5
Stop getting rich from scrolling D=

Why not just say "It's confidential" so you can get a sense of what people believe it is worth (to them)? It's sorta like a P/C, weighted in their favor xD
Reply
#6
Tell them there's no c/o currently, and tell them that reasonable offers are welcome.

If someone bids 600mil on an item that is worth 2 billion that's not what I would call a "reasonable offer."
Reply
#7
Devil's Sunrise Wrote:Do as GMS says, or say that the c/o is currently something you'd expect it to be worth, maybe 5 mill less.

Or be mean and do as I have done, set c/o at a really high pricetag. Managed to milk out 350 mill for meteor 30 and 1.2 billion for MW 20 through that way at the start of HT-killings.

Holy fucking pomegranate 1.2b for a fucking mw 20? what the pineapple.
Reply
#8
Well what I do is anytime I don't have a C/O I just say the price I would like to get. For example there's 15 atk SCG and I have no C/O I would say C/O 1b.
Reply
#9
When I put up a C/O in my shop title I get abused and defamed...I really should stop using my MM to sell stuff.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)