2011-01-28, 05:11 AM
(This post was last modified: 2011-01-28, 05:31 PM by XxSilencer.)
ATM I'm only changing from high - low and low - high when each body part dies, nowhere else like anytime in pre-heads or upon summoning but I never had to do anything at all which I'm hoping will be the case now that I've downgraded back to SP2.
Edit: Well, just did a run this morning while on SP2 now and although it seemed to be better then SP3 I had like 2 body parts poof in and out but wasn't as bad as it was before. Everytime I would kill a body part my ket settings would be transparent so I would change graphics once and it would be fine again, by the time I killed the parts that were poofing in and out everytime I killed something else I didn't have to do anything any there were no transparent problems or anything. Looks like I'm just going to have to get used to this even though there SHOULDN'T be any problems with XP and I never had any problems before I reformatted..
Edit: Well, just did a run this morning while on SP2 now and although it seemed to be better then SP3 I had like 2 body parts poof in and out but wasn't as bad as it was before. Everytime I would kill a body part my ket settings would be transparent so I would change graphics once and it would be fine again, by the time I killed the parts that were poofing in and out everytime I killed something else I didn't have to do anything any there were no transparent problems or anything. Looks like I'm just going to have to get used to this even though there SHOULDN'T be any problems with XP and I never had any problems before I reformatted..